T-HOBBY Высокопроизводительный карбоновый пропеллер AMZ 23*10 для 3D самолетов 84-89" T-Motor tdi

Доставка в течение 2 недель. AMZ 23X10 AM780/AM850+AM216A AMZ 23x10 Power System Matching AM216A 5~14S ESC AM780 KV160 16.7kg MOTOR&MAX. THRUST AM850 KV195 18.8kg MOTOR&MAX. THRUST 84''~89'' 55~65CC 3D aircraft 12S 4500~5800mAh Recommended battery Technical Drawing Specification Model NO. AMZ23*10 Operating Environment Temperature -30~50℃ Diameter 23 Inch Storage Temperature/ Humidity -10~50℃/<85% Pitch 10 Inch Package Size 640*80*35mm Weight (Single Blade) 76g Package Weight 225g Material CF+Epoxy Recommended Thrust/RPM 11.1kg/5800 RPM T-MOTORSeries IntegratedPropeller Recommended Max. Thrust/RPM 23.8kg/8520 RPM Analysis Chart Packing List Note （1）Prop marked with "L" is for CW which "R" for CCW (aerial view). （2）Please be careful when using the propellers as the spinning propellers may cause serious injury. （3）Propeller structural strength has been rigorously tested. Use within the recommended maximum thrust range. Exceeding the ultimate thrust limit will damage the propeller blades.Do not test blade strength by hand-bending, as this does not replicate actual flight stress conditions and may cause blade damage. （4）Please make sure all the accessories are mounted properly. （5）Please check on the propellers before flight and make sure they are in good condition. Please replace propellers with new ones if fault is found with them. （6）Propeller storage requirements: •Avoid corrosive gases and hazardous environments. •Maintain ambient conditions within: Temperature range: -10°C to 50°C Relative humidity: ≤85% RH •Strictly adhere to these parameters during long-term storage. （7）Please apply anaerobic screw locking glue of medium or above strength when install propellers onto motors. （8）Please use the propellers in compliance with local laws and regulations.